I designed a clip to help keep my brothers drawing board from slipping while he was using it. Show below is the 2D sketch that I drew to get the profile for the clip. The largest table it can be used with is 40mm and the clip is designed to hold a bar just over 19mm in diameter. The arm that bar slides along is sloped to help it clip in more securely and the top arm is at a…
After my previous post about how to replace an Eir F2000, I decided to write a post about my Home Networking Setup. Below is a diagram of my full home networking setup: I have Eir’s Fibre To The House (FTTH), I get speeds of 300Mbps down and 50Mbps up. This comes into the house through an underground fibre cable. This cable is terminated in an Underground (UG) Termination box and then goes to an Optical Network Termination box which converts…
I recently got Eir’s Fibre To The House (FTTH), I get speeds of 300Mbps down and 50Mbps up which is a big improvement over the 2Mbps down and 0.5Mbps up I previously had. It is a great service and I am very happy with it! BUT the Eir F2000 (Just a rebranded Huawei HG659b) which is supplied with the installation is a terrible piece of equipment! It constantly drops connection and has to be restarted due to unknown software issues a…
I had to design a new logo for the University of Limerick Computer Society. The old logo of the Society was a Shark called Sharky: The Students Union like us to try and incorporate their logo into any new Clubs & Societies logos. We are known as the Wolves! I decided to draw the new logo in Illustrator because the logo needed to be a vector graphic so that it could be resized easily. The easiest way I could think…